Step 6: Give the New Switches a Quick Test Wrap the exposed copper part around the screw terminal, then tighten the screws firmly (make sure exposed wires aren’t touching other wires). In order to rewire the new switch, you’ll need to loosen the terminal screws if they’re tightened all the way.Īfter that, you’ll need to attach the feed, neutral, and ground wires exactly as they were attached to the old switch. Once all the wires are detached, remove the old light switch and bring in the new one. You can also use needle-nose pliers to help you get thick wires off the switch. To do that, you’ll need to remove any old electrical tape insulation and/or wire nuts ( see size chart here) to uncover the terminal screws and use the screwdriver to loosen the connection to the wires. Start by taking a good look at the old switch and where all the wires are connected.Īfter that, go ahead and remove all the wires. ![]() Once the faceplate is off, use a voltage tester to make sure no electricity is coming from the old switch. Make sure that you do that gently so that you don’t crack or break the faceplate. ![]() Remove the screws from the old faceplate and use a flathead screwdriver to pry it off the wall and expose the old light switch directly. When in doubt, simply shut off the electricity of the entire house to avoid any problems moving forward. Once you’re back, make sure that the electricity is off by testing out all the working light switches in the room and make sure that no lights will turn on. Locate the breaker responsible for electricity in the said room (usually labeled) and shut it off. To do this, head to the circuit breaker in your house and open the metal door. To avoid the risk of electrocution or shorting the circuit, you must always start by cutting off the electric power from the room where the outlet is placed. Step 2: Turn off the Outlet Power from the Circuit Breaker You might also want to wear protective gear like insulating gloves and protective eyewear for added safety.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |